2025 Ronstan Marine Catalogue - Catalog - Page 254
FEATURES & INFORMATION
Fall Protection Systems
241
SAFETY RAIL SYSTEM
SYSTEM DESCRIPTION
OPTIONS
The complete Safety Rail System consists of the following components:
• One track rail with stop holes at 50mm centres and mounting holes at
100mm centres (centre of the last mounting hole at each end of the track rail
is located 48mm from the end).
• A single car assembly for an S30 system, or for a S22 system a maximum
of 3 independent car assemblies, with each car assembly dedicated to an
individual user and incorporating a spring-loaded plunger.
• Each individual car has a single attachment point for personal protection
equipment.
• The spring-loaded plunger allows the car assembly to be fixed in position
at any of the stop holes in the track rail. The plunger can be disengaged
to allow the free movement of the car assembly along the rail.
• Longer runs can be achieved by using more than
one section of track rail and trimming to length
as required, provided that the distance between
mounting fasteners never exceeds 100mm. The
joining insert should be used to aid alignment when
fitting multiple sections of track rail.
• Additional sliding cars for supporting tools or
equipment can be connected to the main
tandem car with the connector plate.
• Optional end stop cover plates.
• Black or silver anodised cars and track.
• Two end stops installed at the extremities of the track rail.
RC12281S
END STOP
RCC22-2A TANDEM CAR*
(or RCC22-1A SINGLE CAR)
LANYARD
ATTACHMENT POINTS
RCC22-3A & RCC22-5
(OPTIONAL EQUIPMENT CAR & CONNECTOR PLATE)
RC1220-3.0S
TRACK RAIL
* Tandem car is required if the user’s weight while working or accessing the work site is supported by the car, as the tandem car provides separate attachment points
for both the working line and fall arrest safety line, as recommended in the EN363 standard: Personal fall protection equipment - Personal fall protection systems.
TRACK RAIL MOUNTED IN VERTICAL PLANE
TRACK RAIL MOUNTED IN HORIZONTAL PLANE
IMPORTANT ADVICE
Ronstan Fall Protection Systems are tested and certi昀椀ed to relevant European and Australian
These systems must only be used with personal protection equipment (harnesses,
Standards, and are appropriate for single person use (or, for S22 Safety Rail Systems, up to
lanyards, fall arresters and other devices) that are approved to the relevant standards for
a maximum of three simultaneous users, with one dedicated car for each individual user)
such equipment, such as EN363. Each harness or device must be secured to a separate
with an energy absorber to the EN355 standard. Testing for conformity to these standards
attachment point. Full product range details can be found at www.ronstan.com. Installation,
is witnessed by a Recognised Organisation, member of the International Association of
usage and maintenance information is available under the SUPPORT tab on the site.
Classi昀椀cation Societies (IACS).
