2025 Ronstan Marine Catalogue - Catalog - Page 278
ANDERSEN WINCHES
Three Speed Electric
265
THREE SPEED
ELECTRIC WINCHES
Empowered Sailing
Manual operation
Andersen Three Speed electric winches are the perfect solution for larger
boats, of 16m (60ft) or more, providing the power and control to safely
hoist and trim sails of any size at the push of a button.
In addition to the host of standard features that make Andersen selftailing winches the benchmark for quality and performance, Andersen
Three Speed electric winches are engineered with unsurpassed levels of
performance, monitoring and protection.
Manual operation is always available as a backup.
Powerful and e昀케cient, high quality motor
At the heart of each Andersen Three Speed electric winch is a powerful European engineered
and manufactured series wound motor. Carefully matched with the optimum gearbox
these winches deliver high speed at low load for fast sheeting in, and low speed at high load
for safe, 昀椀ne tuning when trimming. For maximum performance and e昀케ciency they are
supplied in a 24 volt version, providing smooth operation across a wide working load range.
Illuminated “intelligent” push buttons
Three Speed electric winches are supplied with push buttons with integrated LED which
illuminates when power to the winch system is on. The push buttons incorporate a hinged
safety cover to prevent inadvertent winch operation and are water resistant rated to IP67.
The push buttons also act with the controller to 昀氀ash status codes that assist with trouble
shooting in the event of overload or where other system protection intervention occurs.
Unrivalled monitoring and protection
Integrated overload protection – The controller is pre-set to stop the winch if the
maximum pull load is exceeded. Operation can resume within a few seconds when the
load returns below the limit.
Thermal overload protection – The motor is 昀椀tted with a thermal cutout that disables
the motor in case of overheating; it automatically resets after the temperature returns
to normal.
Reverse polarity protection – An integrated 5 amp fuse protects the controller
against incorrect cable connection.
Accidental start protection – Winch operation is disabled if a push button is already
inadvertently pressed when the power supply is turned on at the circuit breaker or
battery.
Low voltage detection – Operation is disabled if the battery charge level is low,
which prevents further drain on batteries and avoids triggering low voltage reset of
navigation instruments and other electronic devices.
Continuous run time limit – Operation is disabled if continuous run time exceeds 10
minutes.
